引用本文:陈素娟,周 嫣,黄敏方,方志欣,卢其芳.恒牙列骨性Ⅲ类错(牙合)矫治前后(牙合)平面及下颌平面变化的临床观察[J].中国临床新医学,2019,12(8):856-859.
【打印本页】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 1672次   下载 1546 本文二维码信息
码上扫一扫!
分享到: 微信 更多
恒牙列骨性Ⅲ类错(牙合)矫治前后(牙合)平面及下颌平面变化的临床观察
陈素娟,周 嫣,黄敏方,方志欣,卢其芳
545000 广西,柳州市中医医院口腔科(陈素娟);530021 南宁,广西壮族自治区人民医院口腔正畸科(周 嫣,黄敏方,方志欣,卢其芳)
摘要:
[摘要] 目的 了解恒牙列骨性Ⅲ类错(牙合)患者单纯正畸掩饰性治疗前后(牙合)平面、下颌平面的变化及其相关关系。方法 回顾性分析12例恒牙列骨性Ⅲ类错(牙合)患者的临床资料,其中ANB角平均(-3.33±1.74)°,SN-MP角平均(37.67±4.89)°。拔下颌左右第二或第三恒磨牙,配合下颌颊棚区微种植体支抗或多曲方丝弓技术矫治,比较矫治前后X线头影测量指标变化情况,分析矫治前后牙颌颅面变化与(牙合)平面、下颌平面变化的相关关系。结果 矫治后ANB角平均增大(1.79±1.62)°;OPP-FH平均减小(2.83±2.92)°,FH-OP平均减小了(2.25±2.13)°,矫治前后比较差异有统计学意义(P<0.05);OPA-OPP、FH-MP、SN-MP矫治前后比较差异无统计学意义(P>0.05)。相关分析结果显示,前面高、前下面高变化与下颌平面变化之间存在正相关关系(P<0.05)。结论 恒牙列骨性Ⅲ类错(牙合)患者经过合理的支抗设计,可以得到良好的矫治,患者正侧貌也可一定程度改善,(牙合)平面及下颌平面也可以得到较好控制。
关键词:  骨性Ⅲ类错(牙合)  (牙合)平面  下颌平面  正畸掩饰性治疗
DOI:10.3969/j.issn.1674-3806.2019.08.09
分类号:R 783.5
基金项目:广西科学研究与技术开发计划项目(编号:桂科攻1598012-5)
Clinical observation on the changes of occlusal plane and mandibular plane before and after treatment of skeletal class Ⅲ malocclusion of permanent dentition
CHEN Su-juan, ZHOU Yan, HUANG Min-fang, et al.
Department of Stomatology, Liuzhou Hospital of Traditional Chinese Medicine, Guangxi 545000, China
Abstract:
[Abstract] Objective To investigate the changes of occlusal plane and mandibular plane before and after orthodontic treatment in patients with skeletal class Ⅲ malocclusion of permanent dentition and their correlation. Methods Twelve patients with skeletal class Ⅲ malocclusion permanent teeth were selected as the study subjects and their clinical data were retrospectively analyzed. The mean of ANB angle was (-3.33±1.74)°, and the mean of SN-MP angle was (37.67±4.89)°. The second or third permanent mandibular molars were extracted and treated with micro-implant anchorage or Multiloop Edgewise Arch-Wire. The changes of cephalometric parameters were compared before and after treatment and the correlations between the changes of maxillofacial surface and the changes of occlusal plane and mandibular plane were analyzed before and after treatment. Results After correction, the ANB angle increased by (1.79±1.62)degrees, and the OPP-FH angle decreased by (2.83±2.92)degrees, and the FH-OP angle decreased by (2.25±2.13)degrees, with significant differences before and after treatment(P<0.05). There were no significant differences in OPA-OPP, FH-MP and SN-MP between preoperative treatment and postoperative treatment(P>0.05). Correlation analysis showed that there was a positive correlation between the changes of anterior height and anterior-inferior height and the changes of mandibular plane(P<0.05). Conclusion As long as the anchorage design is reasonable, the skeletal class Ⅲ malocclusion can be corrected, and the patients′ normal profile can be improved to a certain extent, and the occlusal plane and the mandibular plane can be well controlled.
Key words:  Skeletal class Ⅲ malocclusion  Occlusal plane  Mandibular plane  Orthodontic masking treatment